Filter
Top Products
SCPI
COMMAND SUMMARY
before changing to the next frequency. After
*RST,
the value is 100
PUS
(
MIN
).
l
LIST:DWELl:POINts?
[MAXimumlMINimum]
Returns the number of dwells entered using the
LIST:DWELl
command. After *RST returns a 1.
l
LIST:FREQuency
(Cnum>[freq
suffix]
lMAXimumlMINimum)i*801
l
LIST:FREQuency?
Sets and queries a list of frequencies that the synthesizer phase locks
to in the sequence entered when the list mode is selected.
*RST value is the (MAX + MIN)/2.
l
LIST:FREQuency:POINts?
CMAXimumlMINimum]
Returns the number of frequencies that have been entered into the
list frequency array. After *RST returns a 1.
l
LIST:MANual
<num>
l
LIST : MANual?
Sets and queries the list point number to go to and lock. The value is
a
unitless
value that is limited between 1 and the maximum number
of points in either of the three arrays. This command has no effect
unless the list mode is set to manual. This value may be bumped if
the number of list frequencies is changed. *RST value is 1.
l
LIST:MODE
AUTOlMANual
l
LIST:MODE?
Selects and queries whether the list is played back automatically or
manually as described in LIST : MANual.
LIST:MODE
LIST:TRIGger:SOURce How the list is played back.
BUS
EXTernal
AUTO IMMediate
Each new frequency point is
stepped to automatically,
after waiting the specified
DWELl
time.
AUTO Wait for a <GET> or *TRG
over the HP-IB before
advancing to the next
frequency in the list.
AUTO
Wait for a signal to be
received on the external
input before advancing to
the next frequency in the
list.
MANual Don’t care
Only the list point
specified by LIST:MANual
is played back.
HP 8360
User’s Handbook
Operating and Programming Reference
S-39