Baldor MN1928 Home Security System User Manual


 
Operation 6-5MN1928
3. In the Select Controller dialog, go to the drop down box near the top and select the PC
serial port to which the NextMove ES is connected. If you are unsure which PC serial port
is connected to the drive, select Scan all serial ports. If the NextMove ES is connected
using USB, it will be scanned automatically.
Click Scan to search for the NextMove ES.
When the search is complete, click ‘NextMove ES’ in the list to select it, and then click
Select.
Note: If the NextMove ES is not listed, check the serial or USB cable between the
NextMove ES and the PC. Check that the NextMove ES is powered correctly.
Click Scan to re-scan the ports.
4. A dialog box may be displayed to tell you that WorkBench v5 has detected new firmware.
Click OK to continue. WorkBench v5 reads back data from the NextMove ES. When this is
complete, Edit & Debug mode is displayed. This completes the software installation.