Baldor MN1928 Home Security System User Manual


 
Introduction 2-3MN1928
2.2 Receiving and inspection
When you receive your NextMove ES, there are several things you should do immediately:
1. Check the condition of the packaging and report any damage immediately to the carrier
that delivered your NextMove ES.
2. Remove the NextMove ES from the shipping container but do not remove it from its anti-static
bag until you are ready to install it. The packing materials m ay be retained for future shipment.
3. Verify that the catalog number of the NextMove ES you received is the same as the
catalog number listed on your purchase order. The catalog/part number is described in
the next section.
4. Inspect the NextMove ES for external damage during shipment and report any damage to
the carrier that delivered it.
5. If the NextMove ES is to be stored for several weeks before use, be sure that it is stored
in a location that conforms to the storage humidity and temperature specifications shown
in section 3.1.1.
2.2.1 Identifying the catalog number
NextMove ES cards are available with a number of optional backplane connector cards. As a
reminder of which products have been installed, it is a good idea to write the catalog numbers
in the space provided below.
NextMove ES catalog number:
NES002-501
Installed in: ________________________
Date: ______
Backplane catalog number: BPL010-50_______
A description of the catalog numbers are shown in the following table:
Catalog
number
Description
NES002-501 NextMove ES controller card with USB connection
BPL010-501 Backplane card: Non-isolated
BPL010-502 Backplane card: Opto-isolated with ‘PNP’ (current sourcing) outputs and
‘active high’ inputs.
BPL010-503 Backplane card: Opto-isolated with ‘NPN’ (current sinking) outputs and
‘active low’ inputs.