Baldor MN1928 Home Security System User Manual


 
Basic Installation 3-1MN1928
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove ES.
This section describes the mechanical installation of the NextMove ES.
3.1.1 Location requirements
You must read and understand this section before beginning the installation.
CAUTION: To prevent equipment damage, be certain that input and output signals
are powered and referenced correctly.
CAUTION: To ensure reliable performance of this equipment be certain that all
signals to/from the NextMove ES are shielded correctly.
CAUTION: Avoid locating the NextMove ES immediately above or beside heat
generating equipment, or directly below water steam pipes.
CAUTION: Avoid locating the NextMove ES in the vicinity of corrosive substances or
vapors, metal particles and dust.
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
H The NextMove ES is designed to be mounted in a IEC297 / DIN41494 rack with card
frames and guides to support the card.
H The NextMove ES must be installed in an ambient temperature of 0°C to 40°C (32°F to
104°F).
H The NextMove ES must be installed in relative humidity levels of less than 80% for
temperatures up to 31°C (87°F) decreasing linearly to 50% relative humidity at 40°C
(104°F), non-condensing.
H The NextMove ES must be installed where the pollution degree according to IEC664 shall
not exceed 2.
H There shall not be abnormal levels of nuclear radiation or X-rays.
3 Basic Installation
3