Heat & Glo LifeStyle RED60 2159-900 Indoor Fireplace User Manual


  Open as PDF
of 98
 
Heat & Glo • RED60 • 2159-900 Rev. R • 9/1286
Figure14.4AirShutter
Figure14.3FixedGlassAssembly
I. FixedGlassAssembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
RemovingFixedGlassAssembly
1. Remove the decorative front.
2. Locate the four spring latches that are on the lower left
and right of the replace.
3. Use both index ngers to release spring latches. See
Figure 14.3.
4. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and tilt glass “out” and “down”.
Lower gently to rest on side supports. See Figure 14.3.
Allow top of glass assembly to tilt forward. Lift glass
assembly “up” and “out”.
ReplacingFixedGlassAssembly
1. Locate glide tabs on lower left and right corners.
2. Place glass bottom resting on right and left support.
Tilt top of glass assembly toward replace.
3. Allow of the gasketing of the glass assembly to touch
the face of the replace. Lift the glass “up” and “in” to
upper glass clip anges.
4. Hold bottom of the glass as you allow the glass as-
sembly to seat over the four lower glass clips. See
Figure 14.3.
5. Assure proper left and right placement of glass and
engage all lower spring latches.
J. InstalltheMesh
A mesh front is included with the RED60 appliance.
For installation instructions, see section 13.E.
K. AirShutterSetting
Air shutter settings may be adjusted by a qualied install-
er at the time of installation. The air shutter is set at the
factory for minimum vertical vent run. Adjust air shutter for
longer vertical runs. See Figure 14.4.
• Loosen the 1/4 in. screw.
• Twist shutter to adjust
• Shutter may be open for longer horizontal vent runs.
• Do not close the air shutter more than 1/16 in. for NG or
1/4 in. for LP.
• Tighten the screw.
NOTICE: If sooting occurs, provide more air by opening
the air shutter.
AirShutterSettings
RED60 NG LP
FULLGRANITEKIT .16in. 1/4in.
LIGHT&MEDIAKIT .06in. 1/4in.
FULLPORCELAINKIT .16in. 1/4in.
SHEETMETAL
REFRACTORY
.16in. 1/4in.
GLASS CLIP
GLASS TAB
GLASS SIDE
SUPPORT
 previous next