Heat & Glo LifeStyle RED60 2159-900 Indoor Fireplace User Manual


  Open as PDF
of 98
 
Heat & Glo • RED60 • 2159-900 Rev. R • 9/1270
Figure13.9NoncombustibleSurfaceFinishingMaterial0-4InchesThick-InsideFitMethod
1-11/16 IN.
1-11/16 IN.
20-1/2 IN.
1-3/8 IN.
1-3/8 IN.
65-1/2 IN.
FIREPLACE VIEWING AREA
= CLEARANCE FROM VIEWING AREA TO NON-COMBUSTIBLE FINISHING MATERIAL
(INSIDE FIT METHOD)
17-1/8 IN.
62-3/4 IN.
Ensure that no non-combustible nish materials are in-
stalled within 1-11/16 inches of top and bottom and 1-3/8
inches from right and left sides of replace opening. This
will ensure adequate clearance for required mesh front.
See Figure 13.9.
Refer to Section 1.E and 1.F of this manual for denition
and qualications and denition of non-combustible and
combustible materials.
E. MeshFronts
WARNING! Risk of Burns! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
A mesh front is included with the RED60. This is the door
approved with this appliance model. It must be used.
To attach the mesh front to the appliance, use the two
mesh brackets. These brackets are mounted to the un-
derside of the top of the appliance viewing area and are
fastened to the appliance by two screws on each bracket.
See Figure 13.10. There are two hanging tabs on the
back of the mesh front assembly that are bent upward.
Engage these tabs in the slot of the brackets.
Figure13.10MeshFrontInstallation
MESH FRAME ASSEMBLY
MESH BRACKETS
MESH FRAME ASSEMBLY
HANGING TABS
 previous next