Heat & Glo LifeStyle RED60 2159-900 Indoor Fireplace User Manual


  Open as PDF
of 98
 
Heat & Glo • RED60 • 2159-900 Rev. R • 9/12 79
Figure4.SecuringTabsandSheetMetalScrews.
Figure7.OutsideFrontTrimBase.
Figure5.InnerFrontBasePieces.
4-5/8IN.
Figure6.InnerRearBasePieces.
19-3/8IN.
3-3/4IN.
19-3/8IN.
Figure8.MiddleandOuterBasePanGraniteSupportTabs.
REARBASEMESHGRANITESUPPORT
FRONTBASEMESHGRANITESUPPORT
Figure9.RemovingScrewsfromBasepan.
Installation
1. Ensure replace is turned off and glass is cool to the
touch before beginning installation. .Remove back row
and sides of 1/4 inch sheet metal screws from base
pan as shown in Figure 9. The screws will be located
either on top of or underneath the mesh. If underneath
mesh, lift mesh screen up and remove for access to
screw heads. Discard mesh.
2. Remove pilot shield as shown in Figure 10. Discard.
PILOT
SHIELD
Figure10.RemovingPilotShield.
3. Measure granite pieces to ensure you are installing them
in the correct orientation. Install back panel pieces rst.
See Figure 11. These pieces are wider than they are
tall. Install so the side measuring 19-13/16 inches is
the width. Pieces should be installed left to right. Place
granite into rebox, bottom side rst. Tilt the top away
from you, placing it into position. Secure each piece
individually as it is placed into position to keep it from
falling while the next piece is placed.
 previous next