Heat & Glo • RED60 • 2159-900 Rev. R • 9/1274
Figure9.FasteningAngleTabtoSecureInnerBackPanel.
Figure10.FasteningAngleTabtoSecureInnerSidePanel.
Installation
1. Verify the correct base pan is in the appliance before
proceeding with the porcelain installation. The base
pan required for this application has the letters “NNN”
and “NNP” stamped in it. See Figure 8. If the base
pan does not have these letters stamped in it, contact
your dealer.
2. Begin by placing the back panel into the rebox, bottom
side rst, then tilt top backward into position. Secure
with angle tabs and screws in the three pilot holes that
are located on the top of the rebox. See Figure 9.
3. Place each side panel into rebox, bottom side rst,
then tilt top backward into position. Secure with angle
tabs and screws in the pilot holes that have are located
on the top of the rebox. See Figure 10.
Figure8.LocationofBasePanIdentication
NNN
NNP
4. Place rear inside porcelain base piece. Place into bot-
tom of replace with tabs away from the burner. Center
from front to back. There will be a gap between the front
edge of the base piece and the burner area and also
a gap between the back of the porcelain piece and the
rear porcelain panel. These two gaps should be equal.
See Figure 11.
5. Install front inside porcelain base piece. Position into
bottom of replace with tabs facing the outside edge of
the rebox. Center from front to back. There will be a
gap between the front edge of the base piece and the
front of the rebox and also a gap between the back
of the porcelain piece and the burner rail. These two
gaps should be equal. See Figure 11.
6. Install glass frame assembly and spring lock into posi-
tion. Set front porcelain trim shelf into position.
7. Position trim shelf so tabs are facing the glass assem-
bly. Insert into glass frame. See Figure 12.
Figure13.PorcelainTrimShelfInstalled.
EQUALGAPDEPTH
ONBOTHSIDESOF
PORCELAIN.
TABS
Figure11.PlacingPorcelainBasePieces.
Figure12.PositioningPorcelainAccessPanel.
TABS FACE GLASS
ASSEMBLY
GLASSASSEMBLY
GLASSASSEMBLY
ACCESSPANEL