Filter
Top Products
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
20
SECTION 3
Sensor Response Types
Your BT Home Monitor VP1000 and sensors are
pre-programmed with default settings, as follows:
Sensor 1 Front Door Entry Delay 1
Sensor 2 Living Room Home & House
Sensor 3 Kitchen Home & House
You can re-set these sensors and any additional
accessories to behave differently, by assigning
new response types.
Note that some sensors and panel buttons have
24 hour functionality, which means that they are
on permanently and will trigger alerts whether
your system is switched ON of OFF. (Please see
table below.)
CHANGING SENSOR RESPONSE TYPES
The Response Types which can be assigned to
sensors are as follows:
*Setting an entry delay automatically creates an exit delay of 60 seconds. These delay times are user selectable, see Section 4.
There are two entry delay settings to allow different times to be set, if you have more than one entry point.
Response Type What It Does
Home These sensors are instructed to remain dormant, and will not trigger alerts when the
system is in ON HOME mode.
Home / House These sensors are active in both ON HOUSE AND ON HOME modes.
Walk-Thru Sensors are dormant during entry and exit delay periods.
Entry 1 Allows 45 seconds to switch the system off before triggering an alert*.
Entry 2 Allows 45 seconds to switch the system off before triggering an alert*.
Help Silent 24 hour. Sends a Help message but does not sound Siren.
Alarm 24 hour. No current application, reserved for future devices.
Fire 24 hour. Sends a Fire message and sounds Siren.
Non-Alarm 24 hour. No current application, reserved for future devices.
Emergency 24 hour. Sends an Emergency message and sounds Siren.