Filter
Top Products
• LED
• OFF
Turns your system off
• STAR
Gives a status report
• ON
Turns your
system on fully
• ON
Home
Turns your system on,
using the ‘home’
setting
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
MOUNTING USING SCREWS
• Remove the front cover using a screwdriver.
• Gently loosen the screw in the middle of the
circuit board, slide the circuit board down and
remove via the keyhole. Fig 10.
• Push out or screw through the mounting
knockouts in the base.
Fig 10.
• Hold the base against the wall at the selected
location and mark the points for drilling. Then
drill the holes and insert wall plugs.
• Attach the bracket to the mounting surface
with screws provided.
• Return the circuit board to the base.
• Re-attach front cover.
Please remember to have installed both
Movement Detectors before continuing.
INSTALLING THE KEYFOB
There is one Keyfob provided with your BT Home
Monitor VP1000 and it is pre-programmed as
USER 1.
You can use it to turn the security system on and
off and to send Emergency messages.
Another 7 Keyfobs can be registered to your
Control Panel.
ACTIVATING THE KEYFOB
Fig 11.
Press ON and ON Home together to send an Emergency alert.
• The Keyfob is supplied with the battery already
installed.
• Press the STAR button. Fig 11.
• Check that the Keyfob LED flashes and that the
Control Panel gives an audible confirmation.
10
SECTION 2
Flat wall
mounting
knockouts
Circuit board
Circuit board
screw
Corner mounting
knockouts