Filter
Top Products
18
SECTION 3
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
User Codes
Up to 8 users can be given a unique 4 digit User
Code, to turn the system on and off. The Master
Code is USER 1 and is the only code which allows
access to the System Profile menu. The other 7
users can just access the basic user menu.
To change the user codes, follow these steps:
PRESS DISPLAY
Until the display shows
SYSTEM PROFILE.
Enter your MASTER CODE.
This will still be 2580, until
another PIN is selected.
Until display shows CHANGE
USER CODE.
Until display shows USER CODE 2.
Display shows USER CODE 2:
1234. Now overwrite this with
your new USER CODE. The
default user codes from 3 to 8
is: 0000.
Twice to confirm change.
After you have chosen a new code,
select either:
To move to USER CODE 2.
This allows you to choose
separate codes for any
addition users of the system.
Three times, then <OK> to exit to
return to READY.
Switching On and Off
Your BT Home Monitor VP1000 can be switched
on and off using the Control Panel, the Keyfob or
the optional Keypad.
There are different ON settings, as described
below.
Note that your system will not switch ON unless
the display reads BT HOME MONITOR. If NOT
READY is displayed, then at least one sensor
needs to be checked. To do this click SHOW /
OK to review the numbers and names of all
sensors one by one. For further information refer
to the troubleshooting section.
SWITCHING ON HOUSE
This setting is generally used when all occupants
are out, as all sensors are fully active.
PRESS ACTION
Using the Control Panel, press the
ON button.
Using your Keyfob, press the
CLOSED PADLOCK button.
Using your Keypad, press the ON
button and input your USER CODE.
0
HOME
0
ON
ON
NEXT
SHOW / OK
NEXT
NEXT
SHOW / OK
NEXT
SHOW / OK
SHOW / OK