Filter
Top Products
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
Step 6 – Testing Your System
1 PREPARATION
• Make sure all windows and doors are closed
and sensors are undisturbed.
• The Control Panel should read BT HOME
MONITOR or READY.
• If the system is NOT READY, query the Control
Panel by pressing the SHOW / OK button
several times. The source of the problem or
problems will be displayed and stated aloud.
Take the necessary measures to eliminate any
problems before testing the system. For
assistance in clearing problems, please refer to
the Troubleshooting information in Section 7.
2 SENSOR ACTIVATION AND STRENGTH
To test that all sensors are working normally:
PRESS DISPLAY
Twice until the display shows
SYSTEM PROFILE.
Enter default PIN 2580 (or your
new PIN if you have chosen one).
Until display shows
TEST SENSORS.
Activate each sensor in turn
(by opening a door or creating
movement), and listen for the
sound the panel makes.
Display Sound
STRONG Intermittent Tune twice
GOOD Intermittent Tune once
POOR Solid Tune once
Three times, then <OK> to exit
to return to READY.
If you can see the Control Panel, the display will
show the sensor number and test result.
3 KEYFOB ACTIVATION AND STRENGTH
• In READY mode, use the Keyfob to switch the
Control Panel ON. To switch ON, press .
Fig 15.
Fig 15
• The ON indicator light should appear on the
Control Panel. The panel will state aloud,
“Switching on house, please exit now”.
• The exit delay beeps will begin.
• Press the button. The ON indicator light
should disappear, and the display should revert
to READY.
NEXT
SHOW / OK
NEXT
SHOW / OK
0
HOME
• LED
• OFF
this switches the system off
• STAR
pressing this button will give
a system status report
• ON
this switches the
system on fully
• ON Home
this switches the
system on, using the
‘home’ settings
14
SECTION 2