Filter
Top Products
Position of adhesive for flat wall mounting
Position of adhesive for corner mounting
Loosen screw
and pull the
two halves apart
Lens
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
To install the Movement Detector, follow these
instructions:
ACTIVATING THE BATTERY
Fig 8.
• Remove front cover using a screwdriver. Fig 8.
• Remove the red tag from the battery.
• Check that the LED flashes.
• Replace the cover and tighten the screw.
LOCATING
Take some time to determine where you want to
position the detectors in your home, for maximum
effect. Ideally, detectors should be placed in the
most vulnerable rooms, or thoroughfares from
key entry points.
If a Movement Detector is in the line of sight of
the Control Panel, program the sensor as WALK-
THRU ensuring it ignores movement when you
are entering and exiting your home. If you wish
to use the ON HOME setting, which allows you
to switch on the sensors protecting the
perimeter of your home when you are in, you will
need to program the sensor as HOME. Please
refer to Section 5 for more information.
Tips On Effective Positioning:
• Place the Movement Detector on a solid and
stable surface between 1.8m to 2.4m (6ft to
8ft) from the ground.
• Do not point at heat sources such as radiators
or open fires.
• Place away from direct sunlight.
• Do not install outdoors.
• Avoid positioning in draughts.
• Do not install behind partitions.
You have a choice of whether to fit the
Movement Detector using the screws or
adhesive provided.
The detectors can be mounted on a flat wall or in
a corner.
MOUNTING USING ADHESIVE
• If you wish to fix the Movement Detector in
place using adhesive tape, decide where you
want the detector to be positioned, and ensure
the mounting surface is clean. Fig 9.
Fig 9.
• The adhesive is double sided and has two
layers of protective covering in place. Peel back
one layer of the protective film and attach the
adhesive to the back of the Movement
Detector.
• Peel back the remaining layer of protective film
and hold the detector firmly in place against
the mounting surface until firmly attached.
• After fixing the detector in place with the
adhesive, the strength of the bond will increase
as time passes. 50% of strength will be
achieved after leaving for 20 minutes and 100%
of strength will be achieved after 72 hours.
9
SECTION 2