Filter
Top Products
SECTION 4: MASTER FILE ENTRY 4-29
Level, Name, Password. Required. These first three fields are entered to identify up to eight
operators who will be permitted to set / change system parameters for this particular ACU.
User 1 must be established (defaults to operator 1); operators 2 through 7 are optional. Enter
the operator's security code (A through F), name and password.
The security codes A through F control the degree to which the operator may add/change/
delete the system parameters. Code A has the most privileges, code F has the least. For
detailed information concerning operator privilege levels, refer to the applicable ACU
manual.
NOTE
The Level, Name and Password fields are specific to individual SE 422s and apply only to
operators logging in directly via the ACU's terminal port. The fields are not part of the SE 6000
control parameters.
Duress. Optional. A number (1-32) which instructs the SE 422 which action report to use
should a duress event occur. Default is 1.
System. Optional. A number (1-32) which instructs the SE 422 which action report to use
in response to system events in the SE 422. Default is 1.
Op. Override. Optional. A number (1-32) which instructs the SE 422 which action report
to use in response to operator overrides performed on the SE 422. Default is 1.
Alarm Delay. Optional. The amount of time in seconds (10-240) that an alarm condition is
allowed to exist before the alarm contact is closed. Default is 30.
2
11