Westinghouse SE 6000 Home Security System User Manual


 
6-20 SECTION 6: SYSTEM ADMINISTRATION
This feature is enabled / disabled using the REXEXTEND parameter in the $DATAPATH/
NPOLLER.x file where x is the associated 708P poller number. The feature is enabled / disabled
during installation, or may be changed as needed by the system administrator. If changed, the
poller must be halted and restarted for the parameters to take effect. The recognized REXEXTEND
values are:
Parameter missing REXEXTEND defaults to 0 (feature disabled)
REXEXTEND=0 Feature disabled
REXEXTEND=1 Feature enabled
NOTE
The enable / disable condition as set applies to all devices controlled by the poller.
KEY INVENTORY [invtmenu]
This feature is used to control system keys. This is an optional feature and does not effect
operation. The menu screen is accessed from the main menu:
INVENTORY STATUS CODE MENU [statentr]
Key codes and descriptions are selected by the user (Code 1=Key in use is frequently set). Other
code descriptions could be: Key available, Key damaged, Key issued, Key lost, Key reported
stolen. In most cases, from four to ten (maximum) are set. The key codes and descriptions are
entered using the key inventory status code entry screen:
KEY INVENTORY STATUS CODE REPORT [statrprt]
This report lists established key codes (for a current key status report, see Key Inventory Report
(following subsection). A sample screen and report follow: