# Message Explanation
C-2 APPENDIX C: SYSTEM TRANSACTIONS — NUMERICAL SEQUENCE
29 Printer On Log printer switched on.
30 Device Reset 708P / 8xx-series powered up / re-initialized.
31 Return From Failsoft 708P communication restored — no longer in failsoft mode.
32 Power Failed 708P / 8xx-series with 3708 UPS has lost AC power.
33 Power Restored 708P / 8xx-series with 3708 UPS has regained AC power.
34 Tamper Active 708P / 8xx-series tamper input active.
35 Tamper Clear 708P / 8xx-series active tamper input now cleared.
36 COAX Failure Coax cable from ACU to reader shorted.
37 COAX OK Coax cable from ACU to reader repaired.
38 Sensor Failure ACU has lost communication with reader (open coax).
39 Sensor OK Previously failed reader (or open coax) repaired.
40 Printer Error Log printer is not functioning properly.
41 Poller Params Reloaded Host has initialized a poller.
42 Still Held Open DOOR HELD OPEN — Second alert message.
43 Input Point Active A GENERAL input has been activated.
44 Input Point Normal Previously activated GENERAL input point has been cleared.
45 Timeout Device Response from polled ACU by host not received within allotted time
(usually 2 seconds).
46 Unable to Lock Door Host unable to implement automatic or manual command to lock a
door (error on lock).
47 Unable to Unlock Door Host unable to implement automatic or manual command to unlock
a door (error on unlock).
48 Unable to Clear Output Host unable to restore output contact to normal (error on output
clear).
49 Unable to Act. Output Host unable to restore output contact to active (error on output
clear).
50 Not Used Reserved for future applications.
51 Not Used Reserved for future applications.
52 Manual Unlock Timed Timed unlock command entered.
53 Manual Access Granted Manual access command issued.