Filter
Top Products
Model 360E Instruction Manual Operating Instructions
6.7.3. Remote iDAS Configuration
Editing channels, parameters and triggering events as described in this can be performed via the APICOM
remote control program using the graphic interface shown in Figure 6-5. Refer to Section 6.15 for details on
remote access to the M360E analyzer.
Figure 6-5: APICOM user interface for configuring the iDAS.
Once an iDAS configuration is edited (which can be done offline and without interrupting DAS data collection), it
is conveniently uploaded to the instrument and can be stored on a computer for later review, alteration or
documentation and archival. Refer to the APICOM manual for details on these procedures. The APICOM user
manual (Teledyne Instruments part number 039450000) is included in the APICOM installation file, which can be
downloaded at http://www.teledyne-api.com/software/apicom/.
Although Tel
edyne Instruments recommends the use of APICOM, the iDAS can also be accessed and
configured through a terminal emulation program such as HyperTerminal (Figure 6-6). However, all
configuration commands must be created following a strict syntax or be pasted in from of a text file, which was
edited offline and then uploaded through a specific transfer procedure.
05232 Rev B3 75