Filter
Top Products
Model 360E Instruction Manual Operating Instructions
6.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the analyzer’s hardware and software
features, perform diagnostic procedures, gather information on the instruments performance and configure or
access data from the internal data acquisition system (iDAS). For a visual representation of the software menu
trees, refer to Appendix A-1.
The areas access under the Setup mode are:
Table 6-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
KEYPAD
LABEL
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration
CFG
Lists key hardware and software configuration information 6.5
Auto Cal Feature
ACAL
Used to set up and operate the AutoCal feature.
Only appears if the analyzer has one of the internal valve
options installed
7.6
Internal Data Acquisition
(iDAS)
DAS
Used to set up the iDAS system and view recorded data 6.7
Analog Output Reporting
Range Configuration
RNGE
Used to configure the output signals generated by the
instruments Analog outputs.
6.8
Calibration Password Security
PASS
Turns the calibration password feature ON/OFF 6.9
Internal Clock Configuration
CLK
Used to Set or adjust the instrument’s internal clock 6.10
Advanced SETUP features MORE
This button accesses the instruments secondary setup menu
See
Table 6-5
Table 6-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
KEYPAD
LABEL
DESCRIPTION
MANUAL
SECTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various external I/O
channels including RS-232; RS 485, modem communication
and/or Ethernet access.
6.11 &
6.15
System Status Variables
VARS
Used to view various variables related to the instruments current
operational status
6.12
System Diagnostic Features
DIAG
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer’s basic
systems
6.13
CO
2
Concentration Alarms
ALRM
Used to activate the analyzer’s two gas concentration status
alarms and set the alarm limits
6.14
NOTE
Any changes made to a variable during one of the following procedures is not
acknowledged by the instrument until the ENTR Key is pressed
If the EXIT key is pressed before the ENTR key, the analyzer will beep alerting the user
that the newly entered value has been lost.
05232 Rev B3 57