Filter
Top Products
Model 360E Instruction Manual APPENDIX A-3: Warnings and Test Functions, Revision G.4
APPENDIX A-3: Warnings and Test Functions, Revision G.4
Table A-2: M360E Warning Messages, Revision G.4
NAME
MESSAGE TEXT DESCRIPTION
WANALOGCAL
ANALOG CAL WARNING
The A/D or at least one D/A channel has not been calibrated.
WBENCHTEMP
BENCH TEMP WARNING Bench temperature outside of warning limits specified by
BENCH_SET variable.
WBOXTEMP
BOX TEMP WARNING Chassis temperature outside of warning limits specified by
BOX_SET variable.
WDYNSPAN
CANNOT DYN SPAN Contact closure span calibration failed while DYN_SPAN was set
to ON.
WDYNZERO
CANNOT DYN ZERO Contact closure zero calibration failed while DYN_ZERO was set
to ON.
WCONCALARM1
CONC ALARM 1 WARN
Concentration limit 1 exceeded.
WCONCALARM2
CONC ALARM 2 WARN
Concentration limit 2 exceeded.
WCONFIGINIT
CONFIG INITIALIZED
Configuration storage was reset to factory configuration or erased.
WDATAINIT
DATA INITIALIZED
Data storage was erased.
WFRONTPANEL
FRONT PANEL WARN
Firmware is unable to communicate with the front panel.
WO2CELLTEMP 1
O2 CELL TEMP WARN O2 sensor cell temperature outside of warning limits specified by
O2_CELL_SET variable.
WPHOTOTEMP
PHOTO TEMP WARNING Photometer temperature outside of warning limits specified by
PHOTO_TEMP_SET variable.
WREARBOARD
REAR BOARD NOT DET
Rear board was not detected during power up.
WRELAYBOARD
RELAY BOARD WARN
Firmware is unable to communicate with the relay board.
WSAMPFLOW
SAMPLE FLOW WARN Sample flow outside of warning limits specified by
SAMP_FLOW_SET variable.
WSAMPPRESS
SAMPLE PRESS WARN Sample pressure outside of warning limits specified by
SAMP_PRESS_SET variable.
WSAMPTEMP
SAMPLE TEMP WARN Sample temperature outside of warning limits specified by
SAMP_TEMP_SET variable.
WSOURCE
SOURCE WARNING Reference reading minus dark offset outside of warning limits
specified by
REF_SOURCE_LIMIT variable.
WSYSRES
SYSTEM RESET
Instrument was power-cycled or the CPU was reset.
WWHEELTEMP
WHEEL TEMP WARNING Wheel temperature outside of warning limits specified by
WHEEL_SET variable.
1
O
2
option
05233 Rev G.4 A-23