Filter
Top Products
Operating Instructions Model 360E Instruction Manual
To assign or reset the status flag bit assignments, press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X. SYNC WARNING: 0000
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. S
Y
STEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
The <CH and
CH> keys move
the [ ] cursor left
and right along
the bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. See Table 6-27.
For xxample …
ENTR key accepts the
new settings
EXIT key ignores the new
settings
SETUP X. S
Y
STEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press the [?] key repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
6.15.4.8. Instrument ID Code
Each instrument on a Hessen Protocol network must have a unique ID code. The M360E is programmed with a
default ID code of 360. To change this code See Section 6.11.1
User Notes
136 05232 Rev B3