Filter
Top Products
Model 360E Instruction Manual Operating Instructions
6. OPERATING INSTRUCTIONS
To assist in navigating the analyzer’s software, a series of menu trees can be found in Appendix A-1 of this
manual.
NOTES
The flow charts appearing in this contain typical representations of the analyzer’s
display during the various operations being described. These representations may
differ slightly from the actual display of your instrument.
The ENTR key may disappear if you select a setting that is invalid or out of the allowable
range for that parameter, such as trying to set the 24-hour clock to 25:00:00. Once you
adjust the setting to an allowable value, the ENTR key will re-appear.
6.1. Overview of Operating modes
The M360E software has a variety of operating modes. Most commonly, the analyzer will be operating in
SAMPLE mode. In this mode, a continuous read-out of the CO
2
concentration is displayed on the front panel
and output as an analog voltage from rear panel terminals, calibrations can be performed, and TEST functions
and WARNING messages can be examined.
The second most important operating mode is SETUP mode. This mode is used for performing certain
configuration operations, such as for the iDAS system, the reporting ranges, or the serial (RS-232/RS-
485/Ethernet) communication channels. The SET UP mode is also used for performing various diagnostic tests
during troubleshooting.
Mode Field
SAMPLE A RANGE = 500.00 PPM CO2 400.00
<TST TST> CAL SETUP
Figure 6-1: Front Panel Display
The mode field of the front panel display indicates to the user which operating mode the unit is currently running.
Besides SAMPLE and SETUP, other modes the analyzer can be operated in are:
05232 Rev B3 51