Filter
Top Products
The syntax of the pdxtx2afp command is:
pdxtx2afp [-i inputfile | -] [-o outputfile | -]
[[-g common | group ]|[-r resourcepath]]
[-x "xjdl=dfault xjde=dflt" | "cparms"]
[-p passthru_values] [-t "directives"] [-w workingdirectory]
[-i inputfile | -]
Specifies the name of the original Xerox LCDS or metacode job file.
If you specify a dash, -, for this command option, InfoPrint XT
reads from standard input (STDIN). If you do not specify the -i
command option, InfoPrint XT reads from STDIN.
[-o outputfile | -]
Specifies the file in which InfoPrint XT writes the AFP output from
the conversion process. If you specify a dash, -, for this command
option, InfoPrint XT writes to standard output (STDOUT). If you
do not specify the -o command option, InfoPrint XT writes to
STDOUT.
[-g common | group]
Specifies the resource group that contains the resources for the job.
This group name is the same name that you specified when you
loaded the resources with the pdxtloadres command. See the -g
command option on page 45. If you do not specify this command
option, InfoPrint XT looks in the common resource group for the
resources that the job requires.
If you specify the -g command option, do not specify the -r
command option. If you specify both, InfoPrint XT uses the value
of the last command option specified with the command.
[-x "xjdl=dfault xjde=dflt" | "cparms"]
Specifies the Xerox-specific conversion parameters for the job. This
corresponds to the values that you specify for the
other-transform-options attribute if you submit the job using the
InfoPrint Manager pdpr command. See Appendix A, “Conversion
parameters for converting Xerox jobs,” on page 93.
You can specify more than one pair of -x parameters and values,
up to a maximum of 50. If you do not specify the -x command
option, InfoPrint XT uses a default of xjdl=dfault xjde=dflt .
[-p passthru_values]
Specifies pass-through values that you can use to pass information
to InfoPrint XT. If you use InfoPrint Manager with InfoPrint XT,
this is equivalent to the InfoPrint Manager destination-pass-
through
document attribute. To pass information to InfoPrint XT,
use one of these formats:
-p passthru_values
-p -opa=passthru_values
When the value for the -p command option begins with -opa=,
InfoPrint XT reads information from the parameter mapping file
pdxtx2afp.map. It also defines the temporary working directory in
%PDXTWORKDIR%\jobs. The remainder of the value is a series
of one or more keyword and value pairs. Valid keywords and
values are:
62 InfoPrint XT Guide