Filter
Top Products
all InfoPrint XT embeds all AFP character sets, code pages, coded
fonts, overlays, and page segments that the job requires in the AFP
data stream. Specifying xinlr=all is the same as specifying
xinlr=cs:cp:cf:ovly:pseg.
cs InfoPrint XT embeds all AFP character sets that the job requires in
the AFP data stream.
cp InfoPrint XT embeds all AFP code pages that the job requires in
the AFP data stream.
cf InfoPrint XT embeds all AFP coded fonts that the job requires in
the AFP data stream.
pseg InfoPrint XT embeds all AFP page segments that the job requires in
the AFP data stream.
ovly InfoPrint XT embeds all AFP overlays that the job requires in the
AFP data stream.
inlr InfoPrint XT embeds the resources that it loaded from the Xerox
job, as directed by the FILE DJDE commands that the job contains.
This includes both permanent and temporary resources, as defined
by the storage parameter.
The default is that InfoPrint XT only embeds temporary resources
that it loaded through FILE DJDE commands with the D storage
parameter.
[xinvertalign=no
| yes]
Controls how InfoPrint XT aligns the AFP output with pages that are
inverted by the Xerox OUTPUT INVERT command or INVERT DJDE.
xhonorinvert=yes must be set for the job.
If you specify xinvertalign=yes, scan and dot values that you specify with
the xalign conversion parameter align output on the inverted pages in the
opposite direction as the alignment of non-inverted pages. For example, if
you specify xalign=0:-56 for a job that is in the landscape orientation,
non-inverted pages are aligned 56 dots to the left, and inverted pages are
aligned 56 dots to the right.
If you specify xinvertalign=no or omit the xinvertalign conversion
parameter, InfoPrint XT aligns all output pages in the same direction. This
is also true if you specify xhonorinvert=no.
Note:
See the xhonorinvert conversion parameter on page 96 and the
xinvertalign conversion parameter on page 97.
[xjde=dflt
| jde_name]
Specifies the name of the Xerox JDE that the operator starts on the Xerox
printer before the job prints. If you do not specify this parameter, the
default is dflt.
[xjdl=dfault | jdl_name]
Specifies the Xerox JDL that contains the starting JDE. If you do not specify
this parameter, the default is dfault.
[xlinecount=n]
Specifies the maximum number of lines per page for jobs that have no
explicit page breaks, as defined through the Job Entry Subsystem (JES) line
spacing parameter.
Appendix A. Conversion parameters for converting Xerox jobs 97
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|