Filter
Top Products
FONTINDEX - The data stream converter will
interpret data bytes at offset x as table
reference characters, which number the
fonts from number and contain font
references in the low-order z bits.
Explanation: Specifies that the job contains a
FONTINDEX DJDE, and identifies the location and the
numbering of the font indexes that the data stream
converter uses. x, y, and z are integer values.
FONTS - font font_name does not meet naming
requirements.
Explanation: The name of the Xerox font, font_name, is
not in the correct format. Xerox font names must not
exceed 6 characters and can include only uppercase
alphabetic characters, numeric characters, and the
dollar sign ($).
FONTS - The number of fonts listed was number.
.fnt name AFP name(s) line spacing value
fnt_name
fnt_name
.
.
.
afp_name
afp_name
x inches or y pels
x inches or y pels
Explanation: Specifies the fonts that the job lists. x
and y are numeric values. fnt_name identifies the Xerox
font name. afp_name identifies the corresponding AFP
font name, which is either a coded font name or a
character set and code page pair.
FORMAT - font font_name does not meet naming
requirements.
Explanation: The name of the Xerox font, font_name, is
not in the correct format. Xerox font names must not
exceed 6 characters and can include only uppercase
alphabetic characters, numeric characters, and the
dollar sign ($).
FORMAT - The new page positions are:
(x,y) inches or (x,y) pels
Explanation: A new PDE has changed the page
positions at a specific offset in the job. The message
lists the new positions.
FORMAT - The number of fonts listed was x.
.fnt name AFP name(s) line spacing value
fnt_name
fnt_name
.
.
.
afp_name
afp_name
x inches or y pels
x inches or y pels
Explanation: x and y are numeric values. fnt_name
identifies the Xerox font name. afp_name identifies the
corresponding AFP font name, which is either a coded
font name or a character set and code page pair.
FORMAT - A DJDE referenced PDE pde_name,
which contained the following
information:
The print mode will be
portrait|landscape.
The number of fonts listed was x.
.fnt name AFP name(s) line spacing value
fnt_name
fnt_name
.
.
.
afp_name
afp_name
x inches or y pels
x inches or y pels
The new page position is (x,y) inches or (x,y) pels.
Explanation: The job invoked a PDE. pde_name
identifies the name of the PDE. InfoPrint XT indicates
whether this PDE is landscape or portrait. fnt_name
identifies the name of the Xerox font. afp_name
identifies the corresponding AFP font name, which is
either a coded font name or a character set and code
page pair. m and n are numeric values. x and y are
numeric values that represent the horizontal coordinate
and the vertical coordinate.
FORMS - No overlay will appear on the front of
subsequent sheets.
Explanation: Specifies that no overlay prints on the
front of subsequent pages. This might be an
informational message, or it might indicate that an
internal error exists in the job, such as two DJDE
packets set to take effect at the same time.
FORMS - Overlay overlay_name will appear on the
front of subsequent sheets.
Explanation: The FORMS DJDE specifies one form
and specifies either SIMPLEX or BFORM. overlay_name
identifies the AFP overlay that prints on the front of
subsequent sheets.
FORMS - Overlay overlay_name will appear on
both sides of subsequent sheets.
Explanation: The FORMS DJDE only specifies one
form. overlay_name identifies the AFP overlay that
prints on both sides of the sheet.
Appendix E. DJDE report messages: ALTER through XMP 149
|