Filter
Top Products
Descriptor Entry (JDE) or Dynamic Job Descriptor Entry (DJDE) COPIES
option. If you do not specify this parameter, either the DJDE in the data
stream or in the active JDE determines the number of copies.
[xcsmmname=yes | no]
Specifies how InfoPrint XT derives the medium map names that it uses in
the inline form definition for a job. The default is that InfoPrint XT uses
sequentially numbered names that are not related to the contents of the
medium maps. The default numbering begins with AIO00001. If you
specify yes as the value of this conversion parameter, InfoPrint XT creates
medium map names in a format that describes the contents of the medium
map. For information about the format that InfoPrint XT uses for
content-sensitive medium map names, see “Working with content-sensitive
medium map names” on page 34.
[xhonorfcb2=yes | no]
Specifies whether InfoPrint XT honors Forms Control Buffers (FCBs)
specified by the JDL or JDLs for the job. If you specify xhonorfcb2=yes
and the JDL specifies FCB=PROCESS, InfoPrint XT processes FCBs that it
finds in the job data stream. If the JDL specifies FCB=IGNORE, InfoPrint
XT ignores the FCBs. If you specify xhonorfcb2=no, or if you omit this
parameter, InfoPrint XT does not process FCBs, regardless of whether the
JDL specifies FCB=PROCESS or FCB=IGNORE.
[xhonorinvert=yes | no]
Specifies whether InfoPrint XT honors INVERT commands that JDLs or
DJDEs for the job specify. If you specify xhonorinvert=yes, InfoPrint XT
processes INVERT commands that it finds in the job data stream. If you
specify xhonorinvert=no, InfoPrint XT does not process INVERT
commands. If you do not specify this parameter, the default is no.
Note: See the xalign conversion parameter on page 93 and the
xinvertalign conversion parameter on page 97. If you specify
xhonorinvert=no or xinvertalign=no, InfoPrint XT aligns all output
pages in the same direction.
[xhonorshift=yes
| no]
Specifies whether InfoPrint XT honors SHIFT and XSHIFT commands that
JDLs or DJDEs for the job specify. If you specify xhonorshift=yes, InfoPrint
XT processes SHIFT and XSHIFT commands that it finds in the job data
stream. If you specify xhonorshift=no, InfoPrint XT does not process
SHIFT or XSHIFT commands. If you do not specify this parameter, the
default is no. Restrictions apply when you use xhonorshift=yes . See page
6.
[xhonorstaple=yes | no]
Specifies whether InfoPrint XT honors FACEUP, NTO1, and STAPLE
commands, which are subparameters of the OUTPUT PDL command.
These commands control how the printer hardware staples the reports in
the job. The default is that InfoPrint XT ignores stapling commands. See
the descriptions of xstaplemax, xstapleorient, and xstaplesysgen on page
102. For information about stapling restrictions, see page 7.
[xinlr=all:cs:cp:cf:pseg:ovly:inlr]
Specifies the printable AFP resources that InfoPrint XT embeds inline in the
AFP data stream for the job. You can specify one or more values. If you
specify more than one value, separate the values with colons (:). Do not
include any spaces. Valid values are:
96 InfoPrint XT Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|