Filter
Top Products
but do not enter a value for that option. This causes InfoPrint XT to use
the information in the pdxtloadres.rty file to determine the resources to
load.
Note: InfoPrint XT overwrites the information in the pdxtloadres.rty file
with each time the pdxtloadres command runs.
Error information for resources that fail to load
InfoPrint XT also stores information about the individual resources that fail in the
working directory that it uses during the resource load process. Whether you load
resources in the common resource group, a specific resource directory, or an
existing directory determines what InfoPrint XT uses as the working directory. The
working directory for the resource load process is one of these:
v %PDXTWORKDIR%\resources\common\pdxtloadres
v %PDXTWORKDIR%\resources\resgrp\pdxtloadres
v C:\OtherDirectory\pdxtloadres
This
list describes the various files in the working directory:
resname.ext.lst
Contains information that InfoPrint XT generates while it converts the
resource. resname.ext is the actual name of the resource. If the resource load
process failed, InfoPrint XT includes error information in this file.
xxx_corr.lst
Contains information that InfoPrint XT generates while it builds the
correlation table entry for one or more resources of a specific type. xxx
specifies the type of Xerox resource.
xxx_metr.lst
Contains information that InfoPrint XT generates while it creates the
metrics files for one or more resources of a specific type. xxx specifies the
type of Xerox resource. The file includes error messages about any resource
for which InfoPrint XT did not generate a metrics file.
xxx_metr.xrl
InfoPrint XT generates this file when failures occur while it tries to create
metrics files for a specific type of resource. xxx is the extension of the
resource type, such as cme or fnt. The file lists those resources that
InfoPrint XT processed successfully.
resname.axx.failed
Contains output that InfoPrint XT generates when a failure occurs while it
tries to create a metrics file. resname is the actual name of the resource. axx
is the extension of the metrics file for the resource. For example, ajd is the
extension of a metrics file for a Xerox JDL resource. You can ignore the
information in this file.
Notes:
1. InfoPrint XT deletes existing files in the pdxtloadres subdirectory and writes
new information each time that you run the pdxtloadres command. It does not
save any of the information for the previous time the command ran.
2. InfoPrint XT provides a method to display the information from these files so
that you do not have to go to the working directory to access the files. See the
description of the -e command option for the pdxtloadres command in “Using
the pdxtloadres command to load Xerox resources” on page 42.
Chapter 4. Loading Xerox resources 41