Filter
Top Products
53NetBotz Appliance User’s Guide
Exporting the Modbus map
To export the Modbus map to a space-delimited text file:
1. Click View Modbus Map to display the map.
2. Click Save to file... in the upper right corner. A save dialog window opens.
3. Select the location and a file name for the saved data and click Save.
Assigning a register address to a sensor
To assign a Modbus register address to a sensor:
1. Select the pod from the list that hosts the sensor and click Modify Pod Settings....
2. Select the desired sensor(s) from the list and click Generate Register Address. This applies the
first unused register addresses to the selected sensor(s).
To manually assign a register address:
1. Select the pod from the list that hosts the sensor and click Modify Pod Settings....
2. Select the desired sensor from the list and click Modify Register....
3. Enter the register address in the provided field. If you specify an address that is already in use, the
program displays an error message.
Removing a register address from a sensor
To remove a Modbus register address from a sensor:
1. Select the pod from the list that hosts the sensor and click Modify Pod Settings....
2. Select the desired sensor(s) from the list and click Remove Registers. This removes the register
addresses from the selected sensor(s).
Output Control
Note: The Output Control icon appears only when a supported Sealevel I/O device or APC
Switched Rack PDU (up to version 2.74) has been connected to the appliance and configured
using the Serial Devices icon.
For more information on configuring serial devices, see “Serial Devices” on page 99. For
more information about supported Sealevel I/O devices and APC Switched Rack PDUs and
how they connect to the appliance, see the installation and quick configuration manual
included with your appliance.
To configure a supported output control device, double-click the Output Control icon. A list of devices
connected to your appliance appears.
Output control label settings
Select a device from the Output Control Configuration window and click Settings.
1. Type a label for this device in the Label field.
2. Select options for Unplugged alert severity and Unplugged alert profile, and click OK.