Filter
Top Products
31NetBotz Appliance User’s Guide
• Send HTTP Post: Sends an HTTP post to a specified HTTP server with information about the
alert. The alert notification post can include images captured by a camera pod, a graph, and a map
of the sensor-specific data associated with the alert.
Note: The appliance posts all data according to the HTTP Post/FTP Data Delivery
parameters. You must configure the target HTTP server appropriately to receive the
posted data. More information can be found on the APC Web site.
• Send Short Message E-mail: Sends a user-configurable e-mail alert notification for devices with
limited display capabilities, such as cellular telephones and personal data assistants (PDAs). Use
macros supported by BotzWare to specify the contents of the title and body of the e-mail.
For more information on macros supported by BotzWare, see “BotzWare Macros” on
page 133.
• Send SNMP v1 Trap: Sends an SNMP trap that contains information about the alert to a
specified SNMP trap recipient.
• Send SNMP v3 Inform: Sends an SNMP INFORM packet that contains information about the
alert to a specified SNMP trap recipient.
• Send Wireless SMS Message: Sends a wireless SMS message that contains information about
the alert to an e-mail address or phone number.
For more information, see “SMS” on page 100.
• Set Beacon Output State: Set the Beacon to turn on or off in response to an alert.
• Set Output Switch 1: Set an output device to turn on or off in response to an alert.
• Set Output Switch 2: Set an output device to turn on or off in response to an alert.
Note: Set Output Switch 1 and 2 are only available on the NetBotz Rack Monitor 450,
550 and 570 models.
• Set Switch Output State: Generates an output relay that is defined as a Switch Relay.
Note: This alert notification method is designed for use only with relay output
devices.
• Set Lock Output State: Set the lock to lock or unlock in response to an alert.
• Set Outlet State: Set the outlet to turn on or off in response to an alert.
• Set Reader Output State: Set the card reader to enabled or disabled in response to an alert.