Filter
Top Products
43NetBotz Appliance User’s Guide
Sensor configuration
Select a camera from the Camera Pods or Shared Cameras window and click Sensors. The Sensor
Configuration window displays a Sensors list and a Thresholds list. Select a sensor from the Sensors
list to display thresholds defined for the sensor in the Thresholds list.
To modify a sensor:
1. Select the sensor to modify from the Sensors list and click Modify.
2. Enter a label in the Label field. This label can be up to 64 characters, and identifies the sensor in
the Sensor Data pane, Advanced View interfaces, and in alert notifications.
3. From Sensor Value History, select the amount of time that data reported by this sensor is stored
on the appliance. The amount of data available on the appliance affects the maximum amount of
data that can be graphed.
For more information see “Viewing Graphs” on page 27.
4. Click OK.
Threshold configuration
All sensors have a default threshold that is generated automatically by Advanced View. This threshold
provides the typical threshold used for the specific sensor type. Thresholds can be customized.
Sensor thresholds are explained in detail in “Advanced View: Defining Thresholds” on
page 107.
To enable or modify a sensor threshold:
1. Select a sensor from the Sensor selection list.
2. Select the threshold to enable or modify from the Thresholds selection list. Click Edit....
3. The Edit Threshold window appears.
– To enable the threshold, check Enabled.
– To change threshold settings, use the Basic and Advanced controls in the Edit Threshold
window to set new values.
4. Click OK.