Filter
Top Products
LCD SCREEN
36
General settings
a Select the needle stop position (the needle position when the machine is not operating) to be up or down. Select the
down position when using the pivot key.
b Select the operation of the “Needle Position - Stitch Placement” button from the following two sequences (see page
86).
Each press of the “Needle Position - Stitch Placement” button:
“ON” – raises the needle, stops it at a nearly lowered position, then lowers it
“OFF” – raises the needle, then lowers it
c Change the brightness of the Needle Area and Work Area Lights.
d Change the speaker volume.
e Change the shape of the pointer when a USB mouse is used (see page 39).
f Turn both the upper and bobbin thread sensor “ON” or “OFF”. If it is turned “OFF”, the machine can be used without
thread.
g Select the length of time until the screen saver appears. A setting between “OFF” (0) and “60” minutes can be set in
1-minute increments.
h Change the image of the screen saver (see page 40).
i Select the initial screen that is displayed when the machine is turned on (see page 41).
j Press “ON” when using the embroidery data creation software My Custom Design. Refer to the instruction manual
(PDF format) stored in the My Custom Design CD included in this machine.
k Change the display language (see page 41).
l Change the screen display brightness (see page 342).
CAUTION
• If “Upper and Bobbin Thread Sensor” is set to “OFF”, remove the upper thread. If the machine is used
with the upper thread threaded, the machine will not be able to detect if the thread has become tangled.
Continuing to use the machine with tangled thread may cause damage.
a
d
e
f
b
c
g
i
j
k
h
l