Filter
Top Products
How to Create Bobbin Work
7
CREATING BOBBIN WORK (EMBROIDERY)
321
h
Press to unlock all keys and
buttons.
i
Lower the presser foot.
j
While holding both the upper thread and
the bobbin thread, sew a section of the
pattern.
k
Stop the machine, and then tie the upper
thread and the bobbin thread together to
secure the threads.
l
Start sewing again to finish the pattern.
m
Raise the needle and presser foot, remove
the embroidery frame, and then cut the
upper thread and the bobbin thread.
When cutting the threads, be sure to leave an
adequate length of thread so they can be
properly secured.
n
Using a hand sewing needle such as a
ribbon embroidering needle, pull the
bobbin thread to the top (wrong side) of the
fabric, and then tie the upper thread and
the bobbin thread together.
o
Remove the fabric from the embroidery
frame, and check the finished embroidery.
p
If the desired results could not be achieved,
adjust the tension of the bobbin thread and
of the upper thread, and then try sewing the
pattern again.
For more details, refer to “ADJUSTING THE THREAD
TENSION” on page 322.
Memo
• If there is a gap between the start point and
end point of the pattern, cut the threads,
remove the fabric from the machine, and
then use a ribbon embroidering needle to
hand sew stitches to connect the starting
and ending points.
a Right side of fabric b Wrong side of fabric
Memo
• Check bobbin after each bobbin work
embroidery pattern is sewn to make sure
there is adequate bobbin thread for the next
pattern.