Filter
Top Products
How to Create Bobbin Work
7
CREATING BOBBIN WORK (SEWING)
315
h
Use the presser foot lever to raise the
presser foot.
i
With the wrong side facing up, place the
fabric under the presser foot.
a Wrong side of fabric
j
Turn the handwheel toward you
(counterclockwise) to feed the needle into
the fabric or punched hole. Position the
upper thread over the presser foot and
lightly hold then, lower the presser foot
lever.
a Punched hole
b Upper thread over the presser foot
k
Pulling the upper thread gently, turn the
handwheel toward you (counterclockwise)
until the mark on the handwheel aligns with
the center top of machine.
→ A loop of the bobbin thread comes out through the
hole in the fabric.
l
Raise the presser foot lever, and then use
tweezers to pull up the bobbin thread and
bring the end of the thread to the top of the
fabric.
m
Align the upper thread and bobbin thread,
and then pass them under the presser foot
toward the rear of the machine.
n
While gently holding threads at the rear of
the machine, turn the handwheel to feed
the needle into the fabric or punched hole
again, and then lower the presser foot lever.
o
Press at lower right of LCD screen.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
Note
• If the bobbin thread does not come up, hold
the upper thread as shown below to pull up
the bobbin thread.
a Upper thread
Note
• Pull the thread while holding down the fabric
so it does not move out of place.