Filter
Top Products
STP-H600/H1000 Series Instruction Manual
2) Connecting the STP Connection Cable
Connect the socket side of the STP connection cable to the STP connector of the
STP pump and connect the pin side to "P.CONNECTOR CON5A" of the STP
control unit.
C
A
U
TI
O
N
Always use the STP pump, STP control unit and the STP connection cables of
the same model name, serial number and cable length. Failure to do so may
result in product damage.
Contact your nearest Seiko Seiki representative if you plan to use units with the
same model name but different serial numbers and cable length; They must
be adjusted. In some cases, the configuration may need more adjustment.
Use the STP connection cable that has a label affixed
STP-H600/H1000
Series
The use of different cables may result in product damage.
3) Connecting the Motor Connection Cable
Connect the socket side of the motor connection cable to the motor connector of
the STP pump and connect the pin side to "INVERTER OUTPUT CON2" of the
STP control unit.
C
A
U
TI
O
N
Use the motor connection cable that has a label affixed
STP-H600/H1000
Series
The use of different cables may result in product damage.
4) Connecting the Emergency Vent. Valve Cable
Connect the emergency vent. valve to the purge port of the STP pump and the
connector to "LEAK VALVE CON8A" of the STP control unit (see Section 3.3.5,
"Connecting the Emergency Vent. Valve").
4-14