Filter
Top Products
STP-H600/H1000 Series Instruction Manual
1.3 Inspection Precautions
Perform inspections of the STP pump and the STP control unit (check of the air cooling fan
and reset of the "BATTERY NG" lamp), following Section 12, "Maintenance and Inspection"
When performing inspections (check of the air cooling fan and reset of the "BATTERY NG"
lamp), always turn OFF the primary power (switch the breaker "OFF") before opening the
front panel, then turn ON the primary power again (switch the breaker "ON").
CAUTION
NEVER touch any portions other than those designated when performing
inspections.
Careless touch may cause electric shock and/or a short-circuiting of the internal
circuit, resulting in product damage or a problem.
1.4 Labels
The following labels are affixed to the STP pump and STP control unit.
Read the contents of the labels before operation. For the positions of the labels, see Figures
“Label Affixing Positions”.
(1) STP Pump Caution Label
This label describes precautions for operating the STP pump.
Follow these precautions.
(2) STP Control Unit Caution Label
This label describes precautions for operating the STP control unit.
Follow these precautions.
1-2