Filter
Top Products
OPERATION
PROCEDURE
71
START POINT RETURN MODE
This operation moves the embroidery hoop to the start point
[*1]
1 Select the start point return operation.
2 Press [SET] to confirm the selection.
If the hoop is returned to the start
point during embroidering, embroi-
dery cannot be continued.
The hoop moves to the start point
position when the SET key is
pressed.
3 End of operation
*1: Start point is the start point of design. If automatic offset is set, the offset start position is taken as the start point.
CAUTION
When performing this operation, do not put your hands or others
under the needle or on the table.
Otherwise, you could get hurt when the needle or hoop has
moved.
FD07
!
***** EMB PAUSE ****
AISIN123.10O 1
58/ 1027
01/15: 23456789AB<D>
1
Press .
***** EMB PAUSE ****
CANCEL EMB ?
［Y=SET,N=ESC］
Press .
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1