Filter
Top Products
OPERATION
PROCEDURE
58
《
《《
《COLOR CHANGE SETTING》
》》
》
COLOR CHANGE MODE
Sets the color change mode - automatic or manual.
1 Change the display to COLOR CHANGE.
2 Select the desired mode.
3 Press [SET] to confirm the selection.
When the manual mode is set, the
presently used needle number is
displayed as shown below.
4 End of operation
To change the needle bar, refer to
the manual operation step
explained in Page 59.
FD07
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1
Press .
*** COLOR CHANGE ***
MODE AUTO
01/15: 23456789ABCDE
1
Press .
Manual
Automatic
AUTO:Lamp OFF
MANUAL:Lamp ON
color change
color change
*** COLOR CHANGE ***
MODE MANUAL
01/15: NO.D
Press .
01/15: NO.D
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: NO.D