Filter
Top Products
OPERATION
PROCEDURE
68
MEMORY MODE
Sets if the design data is stored in memory or not when inputting design data.
1 Change the display to DATA MENU.
2 Change the displayed items.
3 Select "4. MEMORY MODE".
4 Confirm the selection.
5 Select the mode.
MULTI: For storing more than
one design data in
memory.
SINGLE: When one embroidery
data is saved in the
memory, previous
embroidery data is
deleted.
6 Press [SET] to confirm the selection.
7 End of operation
If "SINGLE" is set for MEMORY,
input the data from PC or 335.
To restore the EMB START
screen, press the ESCAPE key.
FD07
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23-456789A<D>
1
Press .
***** DATA MENU ****
1 INPUT DATA PC
2.SELECT DATA
3.DELETE DATA
.
Press .
***** DATA MENU ****
4 MEMORY MODE
5.INITIAL MEMORY
.
Press .
***** DATA MENU ****
4 MEMORY MODE
5.INITIAL MEMORY
.
Press .
Select "MULTI" or "SINGLE" using the
following keys:
and (hoop travel keys)
**** MEMORY MODE ***
MEMORY MULTI
**** MEMORY MODE ***
MEMORY SINGLE
Press .
***** DATA MENU ****
1 INPUT DATA PC
2.SELECT DATA
3.DELETE DATA
.