Filter
Top Products
38
OPERATION
PROCEDURE
BOBBIN COUNTER (SET)
Sets the number of stitches for stopping the machine automatically.
When the counted number of stitches reaches the preset number, the machine
stops automatically.
1 Change the display to FUNCTION MENU.
Determine the number of stitches
to be set for bobbin counter so that
the machine will stop before lower
thread is used up.
2 Select "3. BOBBIN CNT" (bobbin counter).
3 Press [SET] to confirm the selection.
4 Select "PRESET".
5 Input the preset number of stitches.
If you make a mistake, clear the
value you have input by pressing
the CLEAR key and then input the
correct value again.
6 Press [SET] to confirm your input.
When the number of stitches set
by the counter is reached, the
machine automatically stops, by
buzzer sounds and the message
below is displayed.
Press the STOP key to reset the
alarm message, and then perform
the necessary work to restore
operation.
7 End of operation
FD07
Press .
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1
Move the cursor using (hoop
travel key).
*** FUNCTION MENU **
1 DISPLAY ST
2.THRED SNS 2
3.BOBBIN CNT [SET]
.
*** FUNCTION MENU **
1.DISPLAY ST
2.THRED SNS 2
3 BOBBIN CNT [SET]
.
Press .
**** BOBBIN CNT ****
COUNTER 0 ST
PRESET 0 ST
Move the cursor using (hoop
travel key).
123
456
7890
**** BOBBIN CNT ****
COUNTER 0 ST
PRESET 0 ST
Input the preset number using the
numeric keys.
**** BOBBIN CNT ****
COUNTER 0 ST
PRESET 30000 ST
Press .
LOWER THREAD RUN OUT
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1