Filter
Top Products
PREPARATION
21
SETTING THE FABRIC ON THE HOOP
1. Place the fabric (2) on the outer hoop (1) and press the inner hoop (3) into the outer hoop (1).
If the inner hoop (3) cannot be pressed into the outer hoop (1) smoothly, loosen the hoop set screw (4).
2. Check if the fabric is correctly set in the hoop by pressing the center of the fabric gently with the finger as shown
in the illustration below. The fabric should be stretched so that it returns to the state as before when the finger is
released.
CAUTION
Make sure there is no hard item such as a button in the embroidery range.
Otherwise, the needle may be broken causing injury of operators.
Outer hoop (1)
Fabric (2)
Inner hoop (3)
Embroidery hoop set screw (4)
(Checking the setting of fabric)
!