Filter
Top Products
50
OPERATION
PROCEDURE
START POINT RETURN MODE
Sets the mode (automatic/manual) to move the hoop to the start point when the
power is turned ON.
1 Change the display to HOOP MENU.
2 Select "3. START PNT" (start point return mode).
3 Select the setting.
Setting: AUTO / MANUAL
- AUTO: The hoop automatically
travels to the start point
at the completion of
embroidery.
- MANUAL: The hoop stops at the
position where embroi-
dery is completed. To
return the hoop to the
start point, press the
start point return key.
4 Press [SET] to confirm the selection.
5 End of operation
FD07
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1
Press .
***** HOOP MENU ****
1 HOOP FLAT
2.INITIALIZE ON
3.START PNT MANUAL
.
Move the cursor using (hoop
travel key).
Select "AUTO" or "MANUAL" using
the following keys:
and (hoop travel keys)
***** HOOP MENU ****
1.HOOP FLAT
2.INITIALIZE ON
3 START PNT MANUAL
.
***** HOOP MENU ****
1.HOOP FLAT
2.INITIALIZE ON
3 START PNT AUTO
.
Press .
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23456789AB<D>
1