Filter
Top Products
HELIX DN9848E Remote Control Software
User Guide
81
To add channels to an existing output group
1 Select the output group that you wish to add the channels to by clicking on its panel below
the Output Groups button in FastNav
®
, for example, .
2 In the left-hand section of the screen, tick the output channels that you wish to add to the
output group.
3 Click . A form pops up that
allows you to copy data from one
channel to another (using the same
set of options as the Copy Channels
pages earlier in this document).
Depending on the type of group,
various options will be allowed as to
what sections you are able to copy.
If the group contains a PEQ or Filter
section, this will be selected and
greyed out and will always be copied.
This action is taken because the PEQ
section contains absolute parameters
which MUST be the same value.
This form gives the option of
choosing one of the channels already
in the list to be master and its data
copied to the channels about to be added
To remove channels from an output group
1 Select the output group that you wish to remove the channels from by clicking on its panel
below the Output Groups button in FastNav
®
, for example, .
2 In the right-hand section of the screen, tick the output channels that you wish to remove
from the output group.
3 Click . The selected output channels will be transferred to the left-hand section
and removed from the output group.
To jump to the currently selected unit on the DN9848 Units Home screen
You can jump to the DN9848 Units Home screen, which will display the currently selected unit,
by clicking
.
To delete an output group
1 Select the output group that you wish to delete by clicking on its panel below the Output
Groups button in FastNav
®
, for example, .
2 Click .
3 Click Yes at the Remove Group window. Both the left- and right-hand sections and the output
group name field will empty and the output group’s panel will disappear from FastNav
®
.
The screen will change to that shown in section 3.4.4.