Filter
Top Products
HELIX DN9848E Remote Control Software
User Guide
68
To recall a stored memory to the working memory of selected units
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Working Memories, tick the units whose working memory you wish to replace by the
stored memory. To select/deselect all units click
or , respectively.
3 Under Stored Memories, select the system or user memory from which you wish to recall the
working memories.
4 Click .
5 Click Yes at the Write To Working Memory window prompt.
To reset the working memory on selected units
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Working Memories, tick the units whose working memory you wish to reset. To
select/deselect all units click
or , respectively.
3 Click .
4 Click Yes at the Reset Working Memory window prompt.
To reset an individual stored memory back to default on selected units
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Stored Memories, select the system or user memory you wish to reset.
3 Under Working Memories, tick the units whose selected stored memory you wish to reset. To
select/deselect all units click
or , respectively.
4 Click .
5 Click Yes at the Reset Individual Memory window prompt.
To reset all system memories on selected units back to default
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Working Memories, tick the units whose system memories you wish to reset. To
select/deselect all units click
or , respectively.
3 Click .
4 Click Yes at the Reset All System Memories window prompt.
To reset all user memories on selected units back to default
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Working Memories, tick the units whose user memories you wish to reset. To
select/deselect all units click
or , respectively.
3 Click .
4 Click Yes at the Reset All User Memories window prompt.
To lock the system memories, refer to section 3.5.3.