Filter
Top Products
HELIX DN9848E Remote Control Software
User Guide
67
9 STORING/RECALLING MEMORY SETTINGS
All of the memory screens in this section are accessible via the button in FastNav
®
;
refer to section 3.4.1 on page 20.
Note
Working memory refers to the RCS memory, which contains the current show settings.
9.1 Using Working Memories
To copy the working memory of selected units to a stored memory
1 Make sure you are in the RCS Memories screen, press , if necessary.
2 Under Stored Memories, select the system or user
memory in which you wish to store the working
memories, for example, “System 18”.
3 Under Working Memories, tick the units whose working
memories you wish to copy and then store in the
selected memory. To select/deselect all units click
or , respectively.
4 You can, if you wish, collectively name the working memory of the selected units; this will
become the name they will be stored under in the selected memory. Please refer to
section 3.2.5 for details. After changing the name, click and then click Yes at the
Reset Individual Memory window prompt.
5 Click .
6 Click Yes at the Copy From Working Memory window prompt.
Caution on recalling a stored memory to the working memory of selected units
Recalling a stored memory will overwrite your working memory. If you do not wish to lose your working
memory, copy it to a system or user memory first. The RCS acts to protect the working memories of
units that are in Groups containing absolutes and should an attempt be made to effect a change the
RCS will give the following prompt.
If you select OK, then the unit
will be removed from ALL
groups it is associated with.
Alternatively, you can cancel
and no action will be taken.