Filter
Top Products
HELIX DN9848E Remote Control Software
User Guide
16
3.2.5 Changing a name
You can change the name of channels, units, memories etc. The following example shows you how to
change the name of an input channel but the principle is the same for any other name you wish to alter.
To change a name
1 Right click in the field whose name you
wish to change. For example, “Input A”
control panel on the DN9848 Units Home
screen.
2 Move cursor over Select All to highlight it.
3 Left click; all of input channel name is
highlighted.
4 At this point you can type in the new name, for example, “No3 i-p”.
Or:
With the name still highlighted, you can right-click again in
the name field to obtain a menu that allows you to:
Undo – undoes previous operation.
Cut – removes highlighted text and stores it ready for a
subsequent paste operation.
Copy – copies highlighted text without removing it and
stores it ready for a subsequent paste operation.
Paste – pastes stored text.
Delete - removes highlighted text completely without
storing it. Any subsequent paste operation will only paste the stored text from when
you last used Cut or Copy.
Please note that some of the above options are dependent on previous actions and current
operation, so they may not be available, as indicated by being ‘greyed out’. Also, certain
symbols are not allowed, for example, % and £.