Guardian Technologies N7001V2 Smoke Alarm User Manual


 
Ð 87 Ð
Section 7. SETTING THE REAL-TIME CLOCK
PROCEDURE
IMPORTANT:
This method is
different from the
previous method
of setting the
clock.
NOTE: A 6139 alpha keypad must be used to set the real-time clock, or the clock
can be set via the Downloader software. Only users with installer or master
authority level can set the real-time clock.
To enter real-time clock mode, enter installer or master code + #63. A
typical display will show:
TIME/DATE Ð THU
12:01 AM 11/07/96
The day of the week is automatically calculated based on the date entered. Time
and date entries are made by simply entering the appropriate hour, minute,
month, day and year. Pressing the [*] key accepts the entered value and moves
the cursor to the right. Pressing the [#] key moves the cursor to the left of the
display, to the previous position.
To set the time and date, simply enter the correct hour, then press [*] to
move to the minutes and make the correct entry.
Press [*] again, then toggle the AM/PM by pressing any key 0Ð9.
Press [*] to move cursor to the month position and enter the correct month using
a 2-digit entry.
Press [*] and enter the correct date.
Press [*] and enter the correct year.
To exit clock mode, press the [*] key after the cursor is in the year position.
Time adjustments for daylight savings time are handled automatically by the
system (see data field options 2*01 and 2*02).