Filter
Top Products
Ð
63 Ð
Device Programming
This menu is used to program keypads, receivers and relay modules.
From Data Field Programming mode, press #93 to display "ZONE PROG?". Press
0 repeatedly to display "DEVICE PROG?".
DEVICE PROG?
1=YES 0=NO
Press 1 to enter DEVICE PROGRAMMING mode.
DEVICE ADDRESS
01-15, 00 = QUIT
Enter the 2-digit device number as set by the
device's DIP switches (01-15). Press [*] to accept
entry. Enter 00 to return to the main menu. See
NOTE below.
DEVICE TYPE
Select the type of addressable device as follows:
00 = device not used
01 = alpha keypad (6139)
02 = fixed word keypad (6128, 6137)
03 = RF receiver (4281/5881)
04 = output device (4204 relay module)
05 = phone module (4285)
07 = VIM voice interface module (refer to VIM
Ê menu prompts on the following page if this
Ê device type is selected)
08 = 6139AV 2-way voice/alpha keypads
Press [*] to accept entry.
RF EXPANDER
HOUSE ID XX
If device type 03 (RF receiver) is selected, this
prompt will appear. Enter the 2-digit house ID (00-31)
MODULE PARTITION?
If device type 05 (phone module) is selected, this
prompt will appear. Enter the partition number 1-2 in
which the phone module is located.
VOICE KEYPAD NO.
01-15
If device type 08 (2-way voice keypad) is selected,
enter the voice keypadÕs number. The voice
keypads should be numbered in order, starting from
01. For example, if it is the first voice keypad, enter
01; if it is the second, enter 02, etc. This number is
used by the central station operator to locate and
communicate with the premises in case of an
emergency. 01-06 is recommended. Press [*] to
accept entry.
CONSOLE PART.
If device type 01, 02 or 08 was selected this prompt
will appear. Enter the addressable device's default
partition number (01 to maximum number of
partitions programmed for system in field 2*00). This
is the primary partition for which the device is
intended to be used. Press [*] to accept entry.
SOUND OPTION
If device type 01, 02 or 08 was selected this prompt
will appear. Addressable keypads can be individually
programmed to suppress arm/disarm beeps,
entry/exit beeps and chime mode beeps. This helps
prevent unwanted sounds from disturbing users in
other areas of the premises.
Enter a number 00-03 for the keypad sounding
suppression options desired for the keypad as
follows:
00 = no suppression.
01 = suppress arm/disarm & entry/exit beeps.
02 = suppress chime mode beeps only.
03 = suppress arm/disarm, entry/exit and chime
ÊÊÊÊmode beeps.
The screen will display the next device number to be
programmed. Press 00 to exit Menu Mode.
NOTE: Keypad address 00 will always be set to an alpha keypad with no sounder
suppression options.