Filter
Top Products
Operating Instructions Teledyne API Model T360/T360M Operation Manual
120
4.11.7. USB Port Setup
The analyzer can be operated through a personal computer by downloading the
TAPI USB driver and directly connecting their respective USB ports.
1. Install the Teledyne T-Series USB driver on your computer, downloadable
from the Teledyne API website under Help Center>Software Downloads
(www.teledyne-api.com/software).
2. Run the installer file: “TAPIVCPInstaller.exe”
3. Connect the USB cable between the USB ports on your personal computer
and your analyzer. The USB cable should be a Type A – Type B cable,
commonly used as a USB printer cable.
4. Determine the Windows XP Com Port number that was automatically
assigned to the USB connection. (Start → Control Panel → System →
Hardware → Device Manager). This is the com port that should be set in the
communications software, such as APIcom or Hyperterminal.
Refer to the Quick Start (Direct Cable Connection) section of the Teledyne
APIcom Manual, PN 07463.
07272B DCN6552