Filter
Top Products
88 PI-MTE System Manual Version 4.C
Gasket Replacement
To ensure proper sealing, gaskets should be replaced before re-connecting previously
connected fittings.
1. Place one wrench on the male fitting and
hold it in place as you use the other
wrench to rotate the female fitting CCW.
2. Fully loosen the connection.
3. Remove the gasket retaining assembly
from the tip of the male fitting. Replace
the copper gasket and clip the assembly
back onto the fitting.
4. Follow the Installation instructions to
reconnect the fittings.
Swaglok
®
Fittings
Installation
Swagelok Tube Fittings come completely assembled, finger-tight, and are ready for
immediate use. Disassembly before use is unnecessary and could result in dirt or foreign
material getting into the fitting and causing leaks.
Swagelok Tube Fittings are installed in three (3) easy steps, as follows:
1. Simply insert the tubing into the
Swagelok Tube Fitting. Make sure that
the tubing rests firmly on the shoulder of
the fitting and that the nut is finger-tight.
2. Before tightening the Swagelok nut,
scribe the nut at the 6 o’clock position.