Filter
Top Products
30 PI-MTE System Manual Version 4.C
Connecting the Interface (Controller-Computer) Cable
TAXI
®
Cable (6050-0148-CE)
Turn the Controller power OFF (OFF = 0, ON = |) and the Computer power OFF before
connecting or disconnecting the Controller-Computer cable.
To Connect the TAXI Cable:
1. Verify that the Controller power is OFF.
2. Verify that the Computer power is OFF.
3. Connect one end of the TAXI
cable to the 9-pin port on the Interface card.
4. Tighten down the screws to lock the connector in place.
5. Connect the other end of the cable to the "Serial Com" port on the rear of the
Controller.
6. Tighten down the screws to lock the connector in place.
USB 2.0 Cable (6050-0494)
Turn the Controller power OFF (OFF = 0, ON = |) and the Computer power OFF before
connecting or disconnecting the Controller-Computer cable.
To Connect the USB 2.0 Cable:
1. Verify that the Controller power is OFF.
2. Verify that the Computer power is OFF.
3. Connect one end of the USB cable to the USB port on the host computer.
4. Connect the other end of the cable to the USB 2.0 port on the rear of the
Controller.
Connecting the Detector-Controller Cable
Non-Vacuum
Follow this procedure if you are using the camera in a non-vacuum environment. When
operating the camera outside of a vacuum, the camera will typically have the visible nose
already installed. If the visible nose is not installed, refer to Appendix D, "Replacing the
Open Nose with the Visible Nose", page 93, for installation instructions.
Turn the Controller power OFF (OFF = 0, ON = |) before connecting or disconnecting
the Detector-Controller cable.
To Connect the Detector-Controller Cable:
The following procedure assumes that you have a cable (such as the 6050-0321) with slide
latches at both ends. If you do not, follow the instructions for Vacuum but do not change the
visible nose to the open nose.
1. Verify that the Controller power is OFF.
2. Connect male end of the Detector-Controller cable to the “Detector” port on the back
of the Controller.
CAUTION