Filter
Top Products
32 PI-MTE System Manual Version 4.C
Entering the Default Camera System Parameters into WinView
The following instructions assume that you have performed the computer interface
installation.
1. Make sure the ST-133 is connected to the host computer, that it is turned on and that
the computer recognizes the camera peripheral.
2. Run the WinView/32 application. The Camera Detection wizard will
automatically run if this is the first time you have installed a Princeton Instruments
WinView/32 application and a supported camera. Click on the Setup tab and then
select the Hardware function. Then select the “Launch Camera Detection Wizard…”
button in the Controller/Camera tab to start the wizard. Otherwise, if you are
installing a new camera type, click on the Launch Camera Detection Wizard…
button on the Controller/CCD tab to start the wizard.
3. On the Welcome dialog (Figure 6), leave the checkbox unselected and click on
Next.
Figure 6. Camera Detection Wizard - Welcome dialog
4. Follow the instructions on the dialogs to perform the initial hardware setup: this
wizard enters default parameters on the Hardware Setup dialog tabs and gives you
an opportunity to acquire a single test image to confirm the system is working. Note
that this is a test image and it is not acquired using the settings needed for true data
acquisition.
Note: For a step-by-step procedure on basic system operation, refer to the WinView/32
“First Light” section starting on page 37.